A. Layer 2 Edge mode
B. Layer 2 Central mode
C. Layer 2 In-Band mode
D. Layer 3 mode
您可能感興趣的試卷
你可能感興趣的試題
A. Zoning increases security.
B. DNS queries are used for software zoning.
C. Software zoning is more secure than hardware zoning.
D. When using zones and VSANs together， the zone is created first.
E. Zoning requires that VSANs be established before it becomes operational.
A. Virtual Gateway
B. Real-IP Gateway
C. NAT Gateway
D. Central Gateway
A. The FCIP stack supports file-level storage for remote devices.
B. Both require high throughput with low latency and low jitter.
C. The purpose of FCIP is to provide connectivity between host and storage.
D. The iSCSI stack supports block-level storage for remote devices.
E. The purpose of iSCSI is to provide connectivity between separate wide-area SANs.
A. a higher fan-out ratio
B. fully redundant switches
C. 100 percent port efficiency
D. all ISLs contained within a single chassis
E. higher latency and throughput than a core-edge design switch
A. IVR
B. VoQ
C. FSPF
D. VSANs
E. SANTap
A. It operates much like TCP.
B. Flow control is only provided by QoS.
C. It must be implemented in an arbitrated loop.
D. Communication methods are similar to those of an Ethernet bus.
E. N_Port to N_Port connections use logical node connection points.
A. supports multiple protocols
B. works only in a shared or loop environment
C. allows addressing for up to 4 million nodes
D. allows addressing for up to 8 million nodes
E. provides a high speed transport for SCSI payloads
F. may stretch to a distance of up to 100 km before needing extenders
A. Data is accessed using NFS or CIFS.
B. Data is accessed at the block level.
C. NAS is referred to as captive storage.
D. Storage devices can be shared between users.
E. A NAS implementation is not as fast as a DAS implementation.
A. The access layer is the first oversubscription point in a data center design.
B. When using a Layer 2 loop-free design， VLANs are extended into the aggregation layer.
C. When using a Layer 2 looped design， VLANs are not extended into the aggregation layer.
D. When using a Layer 3 design， stateful services requiring Layer 2 connectivity are provisionedfrom the aggregation layer.
E. The data center access layer provides the physical-level connections to the server resourcesand only operates at Layer 3.
A. Partitioning of network resources is enabled.
B. VRFs cannot support path isolation from MAN/WAN designs.
C. VRFs cannot be used to map a virtualized data center to a MPLS implementation.
D. VRFs do not allow for the use of application services with multiple access topologies.
E. An access design using a VRF allows for an aggregation layer service module solution.
最新試題
Which two design recommendations are most appropriate when OSPF is the data center core routing protocol？ （）
What are two characteristics of the SLB One-arm mode？ （）
Which two statements about an interface configured with the asr-group command are correct？ （）
In a collapsed core design， which two benefits are provided by a second-generation Cisco MDS director？ （）
At a certain customer’s site， a NAS is logically in the traffic path but not physically in the trafficpath. The NAS identifies clients by their IP addresses. In which access mode has this NAS beenconfigured to operate？（）
How many channels are defined in the IEEE 802.11b DSSS channel set？（）
During consultation， you find that a customer has only a single asset closet and is looking for asolution that is easy to deploy. Which NAS physical deployment model would you suggest to this customer？（）
What is the traditional mode for a firewall？（）
Which signal and noise values will result in the best phone communication with an access point？（）
Which three of the following descriptions are true about the firewall modes？ （）